Support Center

(Vera3) Vera3 Not Detected

Last Updated: Mar 08, 2013 11:48AM PST

If you've connected your Vera3 as shown in the initial connection instructions and created (and logged into) your account, your computer should be able to find your Vera automatically. 

This is true whether you're using your Vera3 as your main Wi-Fi router or connected via an Ethernet cable to an existing Wi-Fi setup. 


If that's not happening and you're unable to see your Vera3 even though you've connected it properly, check that the WAN light on the front panel is lit up solidly (this may take up to a minute after initial connection). 

If it's not lit up, you may have a problem with your network that needs to be addressed.  Before you start any troubleshooting first check to see that the actual cable and Internet connection aren't the culprit.  If you have another Ethernet cable, try connecting that between the WAN port on the back of your Vera3 and your broadband connection.  Wait up to a minute for the WAN light on the Vera3 to light up solidly.  If it does, problem solved. 

You might also try connecting your computer to the broadband connection using the same cable that you were using for the Vera3.  If you're unable to get Internet connectivity, you may have a problem with your broadband modem. 

Note: Keep in mind that almost all Internet Service Providers (ISPs) briefly lose connectivity now and again. You may be having a temporary problem with yours...see if you're getting Internet service at all without Vera3 connected to confirm.

If after checking the connections and confirming that everything else is working properly  you still aren't able to set up your Vera3, please contact us using the form available at the Contact page of


NEXT: Visit Our User Forum

PREVIOUS: Z-Wave Troubleshooting


Contact Us
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found