Control Your Vera LANGUAGE CONVERTER

Support Center

(Aeon Labs) Putting The Key Fob Into User Mode

Last Updated: May 17, 2013 09:37AM PDT

Before you begin using the key fob scene controller, you have to take it out of its initial setup mode and put it into "use" mode. This  will change the Include, Associate and Remove buttons to work as action buttons instead -- the buttons that will run your Vera Scenes.

You change from setup mode to use mode by pressing the mode button on the back of your remote, using a pin or paper clip to access the small, recessed button as shown:




The green LED will illuminate for 2 seconds confirming that the mode has successfully changed.

NOTE: DO NOT press the mode button for more than 5 seconds - the key fob will be reset to factory defaults (LED flashes red/green)

 

NEXT: Controlling Scenes With The Key Fob

PREVIOUS: Pairing the Key Fob Controller

 





 

Contact Us

http://assets1.desk.com/
veralovers
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
Invalid characters found
/customer/en/portal/articles/autocomplete