Control Your Vera LANGUAGE CONVERTER

Support Center

(Wintop) Pairing Your 3-Way Sensor

Last Updated: May 28, 2013 01:36PM PDT
To pair your 3-way sensor first prepare it by loading it with batteries.  Using a screwdriver, gently pry open the back cover and install two AA batteries as shown below:



You'll notice that toward the bottom of the unit, there is a metal spring contact tab protruding from the rear.  This is the contact button that you will push to put your 3-way sensor in to pairing mode.  But before you do that, you must first put the Vera Smart Controller into pairing mode.

To Pair With The VeraLite Smart Controller:

Tap the "+" button on your VeraLite and you will see the "Ready" light blinking once per second.



 The VeraLite is now in "pairing" mode and ready to recognize the door/window module.

To Pair With The Vera3 Smart Controller

Press the "Z-Wave" button on the front panel.  You will see the green "Z-Wave" light flash once per second.


The Vera3 is now in "pairing" mode and ready to recognize the door/window module.

Now Put The 3-Way Sensor Into Pairing Mode

Bring the 3-way sensor to within 3 feet of your Vera Smart Controller.  Now firmly press and hold for a count of 3 the metal spring contact tab at the bottom rear of the 3-way sensor as shown:



The red LED on the front of the 3-way sensor will begin by blinking red slowly, then blink quickly to show that the pairing has been made.  Release the contact tab by taking your finger off it.  The Vera Smart Controller will start to blink rapidly and then return to blinking slowly.

On the VeraLite, press the "+" button and hold it for 3 seconds to save the pairing.  
On the Vera3, press the "Z-Wave" button and hold it for 3 seconds to save the pairing.

Your 3-way sensor is now paired to your Vera Smart Controller and ready to be installed wherever you want to put it in your house.  

NEXT: Installing the 3-Way Sensor

PREVIOUS: 3-Way Sensor Introduction
 

Contact Us

http://assets1.desk.com/
veralovers
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
Invalid characters found
/customer/en/portal/articles/autocomplete