Support Center

(Remotech) ZTS-100 Smart Thermostat Introduction

Last Updated: May 10, 2013 04:04PM PDT
Congratulations on your acquisition of the ZTS-100 Smart Thermostat!  The ZTS-100 is designed to work with virtually any home HVAC (heating, ventilation and air conditioning) system -- standard gas/electric systems , or systems using a heat pump. Its temperature, programs and modes can be accessed and controlled via your Vera Smart Controller from anywhere.

This smart thermostat gives you two stages of heating and one of cooling, and two program modes for scheduling climate control for weekdays  and weekends.  There are separate time and temperature settings available for each program where you can set your preferred heat and cool set points.

You can also override any of the programmed settings anytime, either manually, temporarily, or permanently. Two batteries provide backup power, and built-in flash memory safely stores your program settings for heating and cooling.

You may prefer to have your ZTS-100 smart thermostat installed by a qualified technician. Its wiring and form factor make it compatible with most homes and climate systems and is an easy installation for a professional.  If you prefer to install the ZTS-100 yourself, please be sure to observe all safety precautions and follow the link at the bottom of the page.

If you won't be installing your ZTS-100 yourself, you can skip the installation page, and move to "Pairing Your ZTS-100."

​NOTE: If you will be installing the ZTS-100 yourself, please observe all safety precautions, especially to turn off the electricity from the appropriate circuit breaker in the room where you'll be installing the ZTS-100.



Contact Us
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
Invalid characters found