Control Your Vera LANGUAGE CONVERTER

Support Center

(Wintop) Pairing Your Wintop Door/Window Sensor

Last Updated: May 28, 2013 01:35PM PDT
To bring your Wintop door/window sensor into your Vera system, you must pair it to your Smart Controller first.  This is an easy, one-time process.

First, put your Smart Controller into pairing mode:

To Pair With The VeraLite Smart Controller:

Tap the "+" button on your VeraLite and you will see the "Ready" light blinking once per second.



 The VeraLite is now in "pairing" mode and ready to recognize the door/window module.

To Pair With The Vera3 Smart Controller

Press the "Z-Wave" button on the front panel.  You will see the green "Z-Wave" light flash once per second.


The Vera3 is now in "pairing" mode and ready to recognize the door/window module.

Put The Wintop Door/Window Sensor Into Pairing Mode:

With the back cover open, bring the door/window sensor within 3 feet of your Vera Smart Controller.  The Smart Controller should already be in pairing mode, ready to pair.

Now press and hold the metal switch in the back of the sensor for 4 seconds and release to start the inclusion or exclude process. The indicator light on the sensor will blink 2 times every second to show that it is in pairing mode.


Your Smart Controller's pairing light will flash quickly to show that the sensor was paired to the system, then return to flashing slowly to show that his has been paired.

Now hold the button on your smart controller for a count of 3 to complete the pairing.  ("+" button on the VeraLite, and "Z-Wave" button on the Vera 3).

Your door/window sensor is now paired to your smart home system and ready to be installed.


NEXT: Installing Your Door/Window Sensor

PREVIOUS: Door/Window Sensor Introduction 


 

Contact Us

http://assets0.desk.com/
veralovers
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
Invalid characters found
/customer/en/portal/articles/autocomplete