Control Your Vera LANGUAGE CONVERTER

Support Center

(Aeon Labs) Installing The 4-In-1 MultiSensor

Last Updated: May 09, 2013 10:37AM PDT
You can install the 4-in-1 multisensor anywhere in the home, either on the ceiling or on a wall.  Installation is simple, and the mounting hardware is included.

To mount the multisensor on the ceiling, simply attach the supplied mounting plate to your desired location, and then slide on the multisensor onto the mounting plate as shown:


The approximate coverage area and range of the multisensor when mounted to a ceiling is shown below:



If you prefer to mount the multisensor on the wall instead of a ceiling, start by mounting the back mount arm to your desired location on the wall, as shown below.

NOTE: It is recommended that you avoid mounting the multisensor on a metal frame (such as a door frame).  Metal in too close proximity to the multisensor can sometimes interfere with the wireless signals.



Next, screw the multisensor's back mount plate into the back arm mount.  Now slide the multisensor's rear panel onto the back mount plate.  You can adjust the sensor to any angle you want by simply tightening and loosening the sensor clockwise (tighten) or counterclockwise (loosen).  The angle of coverage for wall mounting is shown below:


NOTE: The humidity sensor on your 4-in-1 multisensor should be facing toward the bottom of the senor, rather than the top, as shown below:

PREVIOUS: Pairing The 4-in-1 MultiSensor
 

Contact Us

http://assets2.desk.com/
veralovers
Loading
seconds ago
a minute ago
minutes ago
an hour ago
hours ago
a day ago
days ago
about
Invalid characters found
/customer/en/portal/articles/autocomplete